| Remarks： Overview
HIOSO FC830A is an intelligent 10/100M adaptive fast Ethernet fiber
converter (also called optical-to-electrical medium converter).
With its unique link failure alert” function at both optical and
electrical ends, this fast Ethernet fiber converter can completely
replace the fiber converter of Network Management System (NMS) type
and greatly reduce system cost.
FC830A has multi lightning protection function:
Add TVS U5 between the signal line 1、2 and 3、6 of the RJ45
interface. This component can cause short circuit when the twisted
pair meets high voltage thunder, to protect the main chip of the
media converters.
The AC220V input port is consisted of high voltage capacitor C1 and
high quality VDR (voltage dependent resistor) RVI, which can
greatly reduce the resistance instantly when meets high voltage.
FC830A can conduct mutual conversion between 10Base-T/100Base-TX
twisted pair electrical signals and 100Base-FX optical signals.
This fiber converter extends the transmission distance of a network
from 100m over copper wires to 120 Km, and uses two network
transmission technologies (that is, storing & forwarding mode
of the second data link layer and the straight-through mode of the
first physical layer) to implement data transmission the optical
and electrical network connection media. FC830A fiber converter
supports transmission in dual-fiber multi-mode, dual-fiber
single-mode and single-fiber single-mode fibers.
Features
- 10-100 Mbps adaptive, for the convenience of network upgrade;
- Efficient built-in switching core, to implement flow control and
reduce broadcast packets;
- Supporting full-duplex and half-duplex transmission modes and
capable of automatic negotiation;
- Supporting automatic crossing of twisted pair ports, for the
convenience of system debugging and installation;
- Supporting Link Failure Alert (LFA);
- Supporting FX half-duplex/full-duplex transmission modes and link
failure alert function ;
- Supporting switch selection of 10/100Mbps storing & forwarding
or 100Mbps straight-through transmission mode (unique);
- Supporting low-delay transmission;
- Supporting transmission of extra-long packets (with the maximum
length of 1600 bytes);
- Supporting transmission of extra-long packets over VLAN;
- Supporting Quality of Service (QoS) and ensuring transmission of
VoIP packets;
- Supporting Spanning Tree Protocol (STP) to form a redundant
network;
- Extremely low power consumption (less than 2W), low heat
dissipation and capable of stable operation for a long period of
time;
- Supporting multiple types of fiber ports such as dual-fiber
multi-mode、dual-fiber single-mode and single-fiber single-mode, to
satisfy the extended requirements of users.
Application
10/100Mbps fast optical Ethernet long-distance transmission network Technical Specifications
Parameters
| Specifications | Access mode | 10/100Mbps | Standard | IEEE802.3 10Base-T Ethernet,IEEE802.3u,100Base-TX/FX Fast Ethernet,
IEEE802.3x Flow control,IEEE802.1q VLAN,IEEE802.1p QoS,IEEE802.1d
Spanning Tree | Wavelength | 850nm/1310nm/1550nm | Transmission distance | Dual-fiber multi-mode: 2Km; dual-fiber single-mode:
25/40/60/80/100/120Km;single-fiber single-mode: 25/40/60/80/100Km
Category-5 twisted pairs: 100m | Port | One RJ45 port: Connected to STP/UTP category-5 twisted pairs
One fiber port: Multi-mode SC or ST (fiber size: 50,62.5/125m)
Single mode SC/FC fiber port (fiber size: 9/125m)
Single-fiber single-mode SC/FC fiber port (fiber size: 9/125 m) | Conversion mode | Medium conversion, storing and forwarding/straight-through | MAC address table | I K | Buff |
|
